Pairing Your Remote

Your controller and board have been paired before delivery.  Should you need to replace your controller for any reason, please follow the new pairing process

1. With the controller and board turned off, switch your controller settings to Beginner (aka turtle- under the battery cover) AND Low (on the side of the controller).

2. (Different for Juiced Singles/first gen & Juiced Duals)
  • (Juiced Singles, and First Gen boards)- Power the board on and Immediately press the rubber “binding” button with a pin, or sim card tool.  The power light on the board should go out.
  • (Juiced Duals)- Power the board on and then 1-2 seconds after, press the rubber “binding” button with a pin or a sim card tool.  The power light on the board should start alternating through Red, Green and Blue colors.
3. On the controller, hold the throttle in “STOP” position, and switch the power to “ON”.  Continue holding the throttle in “STOP” position until the board's power level indicator light starts rapidly blinking.

Your board and controller should now be paired!  If they are not, please go through these instructions again carefully.  The most common error is turning the remote on before step 3 :p

If for some reason you still can not get your remote to pair with your board, please contact support@juicedboards.com
 

Did you find this article helpful?